COUSSINETS SKF PDF

Comme pour les coussinets et les bandes composites, SKF fabrique de série des rondelles de butée composites à partir de matériaux composites PTFE et POM. For additional information about the meaning and limitations of the product data, refer to SH bushings. Imprimer cette page; Partager. d, 35, mm. D, 60, mm. D1, 68, mm. L, 37, mm. L1, 49, mm. B, , mm. Calculation data. Max. torque, Mv, , N·m. Max. axial load, Pa, 41, kN. Mounting.

Author: Akinogor Kajizilkree
Country: Liberia
Language: English (Spanish)
Genre: Politics
Published (Last): 1 April 2004
Pages: 161
PDF File Size: 7.45 Mb
ePub File Size: 20.69 Mb
ISBN: 251-4-71442-513-3
Downloads: 95072
Price: Free* [*Free Regsitration Required]
Uploader: Samugar

Joints à frottement mécanique, coussinets SH – SHT 48

Check that the counter surface shaft seat and other components such as the housing are clean, deburred and that they do not contain any abrasive particles.

For larger bushings, SKF recommends using a mounting ring fig. Check also the shaft for sharp edges, burrs or surface defects, which could damage the sliding surface of the bushings. Then drive the bushing into place with a mechanical or hydraulic press or by tapping the dolly lightly with a hammer.

  ENERGETSKI MENADZMENT PDF

If composite plain bearings, for example strips, are to be located in a housing using an adhesive, the adhesive should be suitable for the expected operating temperature and should have suitable expansion, aging resistance, strength and curing properties.

Otherwise when the bushing comes in contact with absorbent material it may wick the oil away very quickly. Mounting Skill and care in mounting are prerequisites for long bearing service life. Once all the components have been cleaned and checked, the bushing is ready to be installed.

To facilitate mounting FW busings, smf bushing may be split lengthwise into two halves by using a diamond coated grinding wheel. Sufficient cooling fluid should be applied as well to avoid excessive temperatures, as they can destroy the bushing. To install bushings, with or without a flange, SKF recommends using a mounting dolly particularly for composite fig.

When applying an adhesive, care should be taken so that no adhesive reaches the sliding surface. Care should always be taken when mounting FW bushings not to damage the sliding layer or side faces. SKF also recommends, particularly for larger bushings where more force is required that they be cooled before mounting.

  ISO 8434-4 PDF

In addition, cleanliness, and understanding the causes of premature bearing failure can help too. The position of the lubrication groove of solid bronze bushings depends on whether it is an oscillating or rotating or movement and, for the latter, whether oil or grease lubrication is applied fig. When mounting, thrust washers should be positioned so that the steel backing abuts the housing wall.

Coussinets

To do this, place an O-ring on the dolly to keep the bushing in position. Imprimer cette page Partager Partager cette page.

To facilitate the mounting of small bushings, apply a light coating of oil or grease to the housing bore.

SKF sintered bronze bushings are impregnated with a lubricant and. If no operational cousxinets is available, SKF recommends contacting an adhesive manufacturer for advice.